9mm moisture resistant MDF T&G board bonded to 8mm reconstituted acoustic chip foam, provides impact and airborne sound reduction. Laid straight over subfloor in a brickbond pattern, foam side down with all joints tightly interlocked and fully PVA glued.
The finish flooring can be laid floating on an underlay or fully bonded using Wakol MS260.
|Dimensions:||17 x 600 x 1200mm (0.72sqm).|
|Weight:||5.1kg per panel (7.08kg/sqm)|
|Material:||MDF with reconstituted acoustic chip foam|
|Impact sound reduction:||Circa 35dB*|
IMPORTANT : Fit the Angled Flanking Band (see page #) around the room perimeter as you lay the boards, skirting is then fitted on top of this band, which can then be trimmed off. If skirting is already on, fit the Isolation strip (see page #) against the skirting before laying the boards, this can be trimmed as necessary after installation of the boards.
*When installed as part of a complete party floor construction the system enables a timber floor to meet the sound transmission standards of Approved Document E 2003 and amendments in 2004, 2010, 2013 & 2015.